Stainless Steel Back Plate from TDS.Compatible with all DTD accessories. Holes that let adjust in two different heights. Perforations to pass the single tank straps.

Anodized Aluminum Back Plate from TDS. Holes that let you adjust in two different heights. Perforations to pass the single tank straps. Multiple holes for different accessories.

TDS Anodized Aluminum Reduced Back Plate. Ideal for travel thanks to its light weight: only 500 g. Perimeter edges and perforations completely beveled to avoid damaging equipment and harness straps.

Plate for mounting a single bottle on back plate, in polished aluminum. Includes set of two bottle straps with stainless steel buckle. Also includes a complete set of screws with spherical head, square body to avoid turning when tightening, washers and wing nuts. Approximate weight of the set 1 kg

Plate to fitting single tank to back plate. Stainless steel or aluminum models. It also can be used to mount twins with double tank straps (not included).
Weights: Stainless steel 0.870 kg. Aluminium 0.305 kg.

The TDS Tolok pocket, is a specially pocket designed for technical diving, being valid for both backmount and sidemount systems thanks to the versatility of its design. A pocket designed down to the smallest detail to offer maximum performance to the technical diver.

The TDS Xtrem TK3 is a pocket specially designed for technical diving, being valid for both backmount and sidemount systems, due to the versatility of his design. The pocket is designed with the smallest detail to offer maximum benefits to the technical diver.

Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.

High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.

Ballast system for back plate, consisting of two pockets that are attached to a webbing and end in a riveted ring, which is attached to the holes of the back plate. The left pocket includes a D-ring for attaching a pressure gauge or monitoring device.

D ring 50 mm long stainless steel. Essential for the assembly of harnesses in technical diving.