Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.

Ballast system for back plate, consisting of two pockets that are attached to a webbing and end in a riveted ring, which is attached to the holes of the back plate. The left pocket includes a D-ring for attaching a pressure gauge or monitoring device.

High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.

Replacement bladder for the TDS Iron 20 technical diving wing. Circular design in heat-sealed cordura. Base for welded valves and trachea.

Carrying case with everything you need to service TDS & similars  BPI - low pressure inflators. Includes: Pliers with rounded tips. Cone for inflator button gasket Bush wrench Silicone lubricant 5 mm hexagon socket Set of O-rings in different sizes Plastic flanges.

Technical harness for back plate mounting with all necessary components included and fully adjustable. Mounting and dismounting the back plate is very versatile, as it is fixed with screws of the twin cylinders themselves

TDS Confort Plus Techncial Scuba Diving Harnais: Technical harness for mounting on back plate with trellis, with all necessary components included and fully adjustable. The assembly and disassembly to the back plate is very versatile, since it is fixed with the own screws of the bottle.

The TDS Xtrem TK3 is a pocket specially designed for technical diving, being valid for both backmount and sidemount systems, due to the versatility of his design. The pocket is designed with the smallest detail to offer maximum benefits to the technical diver.

Integral piece D-ring stopper at 45 degrees, in stainless steel.

90 degree d-ring stopper in stainless steel.

D ring 50 mm long stainless steel. Essential for the assembly of harnesses in technical diving.

TDS DIR Harness Scuba Diving Harnais: Technical harness for mounting on back plate (not included), with all necessary components included for a basic DIR configuration. The set is sold disassembled for the diver to assemble on his plate with his personal settings and preferences.