Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.

Anodized Aluminum Back Plate from TDS. Holes that let you adjust in two different heights. Perforations to pass the single tank straps. Multiple holes for different accessories.

TDS Anodized Aluminum Reduced Back Plate. Ideal for travel thanks to its light weight: only 500 g. Perimeter edges and perforations completely beveled to avoid damaging equipment and harness straps.

Ballast system for back plate, consisting of two pockets that are attached to a webbing and end in a riveted ring, which is attached to the holes of the back plate. The left pocket includes a D-ring for attaching a pressure gauge or monitoring device.

High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.

Replacement bladder for the TDS Iron 20 technical diving wing. Circular design in heat-sealed cordura. Base for welded valves and trachea.

Carrying case with everything you need to service TDS & similars  BPI - low pressure inflators. Includes: Pliers with rounded tips. Cone for inflator button gasket Bush wrench Silicone lubricant 5 mm hexagon socket Set of O-rings in different sizes Plastic flanges.

The TDS Xtrem TK3 is a pocket specially designed for technical diving, being valid for both backmount and sidemount systems, due to the versatility of his design. The pocket is designed with the smallest detail to offer maximum benefits to the technical diver.

Integral piece D-ring stopper at 45 degrees, in stainless steel.

90 degree d-ring stopper in stainless steel.

D ring 50 mm long stainless steel. Essential for the assembly of harnesses in technical diving.

Double bolt snap trigger carabiner type in stainless steel, available in various sizes. It's perfect for working with buoys, spools and lines already laid. Available sizes: 115 mm,